Parsed the pin-definition tables out of both datasheets - Table 2-1-1 (CH32L103,
C8T6 column) and Table 2 (STM32F103, LQFP48 column) - and diffed them pin by
pin. Zero mismatches, including OSC_IN/OSC_OUT, NRST, PA11/PA12 for USB,
PA13/PA14 for SWD, and BOOT0. Power pins differ only in naming.
This was the one unverified assumption the whole project rested on: three
boards laid out to a footprint that has to accept either MCU. It holds.
Full table recorded in Documents/pinout-L103-vs-F103.md.
Co-Authored-By: Claude Opus 5 <[email protected]>
Every image and link pointed at docs/, which no longer exists - the README
rendered with six broken images. Repoints them at Documents/, updates the
board table to the real Schematics/Left|Right|Numpad tree, and renames
firmware/ to Firmware/ to match the capitalised convention.
Documents/README.md now describes the whole folder rather than just the
datasheets, since the diagrams and BOM live there too.
Co-Authored-By: Claude Opus 5 <[email protected]>
st.com blocks scripted download and its CSP blocks a browser-side fetch from
leaving the page, so this came from a mirror and is Rev 1 (preliminary, 65pp).
Verified it is the right document and that the LQFP48 pinout and every pin the
swap depends on are present. Flagged in the README as unsuitable for electrical
figures - pull the current Rev 20 by hand for those.
Co-Authored-By: Claude Opus 5 <[email protected]>
CH32L103 datasheet and reference manual, plus the CH334/335 hub datasheet.
Documents/README.md notes which section of each was load-bearing, and flags
the missing STM32F103C8T6 datasheet needed for the pin-number overlay.
Co-Authored-By: Claude Opus 5 <[email protected]>
